Remote Control Is Good Enough; Remote Control Functions - JVC DR-MV5S Instructions Manual

REMOTE CONTROL
70
EN

Remote Control Functions

Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four codes
(1, 2, 3 or 4). The remote control is preset to send 3 code signals
because your unit is initially set to respond to 3 code signals. You
can easily modify your unit to respond to 1, 2 or 4 code signals.
Slide the TV/DVD switch to DVD.
STANDBY/ON
S-VIDEO VIDEO AUDIO
1 – 4
ENTER
Keep pressing SET UP down during step 1.
1
Press the number button "1" for 1, "2" for 2, "3" for 3 or "4"
for 4 to change the remote control code, then press ENTER.
2
Press 1 on the unit to turn off the unit.
3
Press 4 on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4
Press 8 on the remote control to change the unit's code. The
code currently set on the remote control blinks on the front display
panel for approximately 5 seconds, and is applied to the unit.
NOTE:
When "POWER SAVE" is set to "ON" (
change the remote code.
VHS DVD
VHS/DVD
VHS DUBBING
SET UP
pg. 73), it is not possible to
REC
CH
DVD
DV IN
TV Multi-Brand Remote Control
Your remote control can operate the basic functions of your TV set.
In addition to JVC TVs, other manufacturer's TVs can also be
controlled.
Turn off the TV using its remote control.
Slide the TV/DVD switch to TV.
IMPORTANT:
Although the provided remote control unit is compatible with JVC
televisions, as well as many other models, it may not work with your TV,
or in some instances, may have limited function capability.
Keep pressing SET UP down during step 1.
1
Enter your TV's brand code using the number buttons, then
press ENTER.
2
Press 1 on the unit's remote control to turn on the TV and try
operations (
Once you have set the remote control to operate the TV, you do not
have to repeat this step until you replace your remote control's
batteries.
Some brands of TVs have more than one code. If the TV does not
function with one code, try entering another.
3
Press the corresponding buttons to operate the TV: 1,
TV INPUT, CH +/–, TV VOL +/–, number buttons.
For some brands of TVs, you must press ENTER after having
pressed the number buttons.
BRAND NAME
JVC
HITACHI
MAGNAVOX
MITSUBISHI
PANASONIC
RCA
SHARP
SONY
SAMSUNG
SANYO
SEARS
TOSHIBA
ZENITH
0 – 9
ENTER
step 3).
CODE
01, 03
10
02
03
04, 11
05
06
07
12
13
13
08
09
TV INPUT
TV VOL +/–
CH +/–
SET UP