Basic Recording - JVC DR-MV5S Instructions Manual

BASIC RECORDING

28
EN
Basic Recording (DVD)
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/DVD switch to DVD.
ATTENTION:
It is not possible to record programs on a DVD-R disc
which has already been finalized.
STANDBY/ON
S-VIDEO VIDEO AUDIO
VHS DVD
VHS/DVD
VHS DUBBING
DVD lamp
we
1
Load a recordable disc.
For details, refer to "Placing A Disc" (
2
Press VHS/DVD on the unit repeatedly or
DVD on the remote control so that the DVD
lamp lights up on the unit.
3
Press CH +/– or the number buttons to
select the channel you wish to record.
If you record the programs received by cable box or DBS
receiver ...
1) Select "L-1" by pressing CH +/–.
2) Set the cable box or DBS receiver to the appropriate
channel.
REC
CH
4
DVD
DV IN
Press REC MODE repeatedly to select the
recording mode, then press ENTER.
Each time you press REC MODE, the recording mode
changes as follows:
XP ] SP ] LP ] EP ] FR60–FR360* ] FR420,
FR480 ] (Back to the beginning)
* The value is selectable from 1 to 6 hours in 5-minutes interval
by pressing
change the value in 30-minutes interval, press and hold
For details on the recording mode, see "Recording Mode"
( pg. 29).
5
Press 7 on the unit to start recording. Or
while holding 7, press 4 on the remote
control.
6
Press 9 to pause recording.
To resume recording, press 4.
7
Press 8 to stop recording.
It takes about 10 seconds to end the writing session when
you stop recording.
repeatedly after selecting "FR60–FR360". To
w e
pg. 11).
.
w e