Table of Contents
Advertisement
64
EN
Remote Control
Functions
Remote A/B/C/D Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
Before performing the following steps:
Slide the TV/S-VHS/DVD switch to the right.
On the remote control
Keep pressing S-VHS down during steps A – B.
A
Change the remote control code.
Press the number key "1" for A, "2" for B, "3" for C or
"4" for D.
B
Set the remote control code.
Press OK to set the code.
On the unit
C
Turn off the unit.
Press 1.
D
Display the code.
Press 4 on the unit for over 5 seconds while the unit is
turned off. The code currently set appears on the front
display panel.
● If the code displayed on the front display panel is different
from the code set on the remote control, go to step E.
E
Change the unit's code.
Press 8 on the remote control. The code currently set on
the remote control will be applied to the unit.
NOTE:
When "POWER SAVE" is set to "ON" (
impossible to change the remote code.
REMOTE CONTROL
pg. 73), it is
Advertisement
Table of Contents
