Door Options; Wood Overlay/Door Lock Installation - Perlick Signature HP15RS Operation & Installation Manual

DOOR OPTIONS

Perlick residential units offer a variety of door panel design
alternatives; solid stainless steel, solid wood overlay, glass with
stainless steel trim and glass with wood overlay trim.
Solid stainless steel and stainless steel glass doors are shipped from
the factory with decorative stainless steel panels and handles in
place on the appliance.
Solid wood overlay and glass wood overlay doors are designed to
accept a decorative front panel to match surrounding cabinetry
and door handles. The panel and door handles are supplied by the
customer.
All Perlick units accept any of the above door configurations and
are fully interchangable.
IMPORTANT NOTE: Glass with stainless trim and glass with wood
trim may sweat in conditions with relative humidity over 75%.
WOOD OVERLAY INSTALLATION
Before beginning installation, check all components for proper fit
and finish.
WARNING
• All overlay doors require a trim panel of at least 3/4" thick.
• The solid wood overlay panel should not weight more than
20 pounds.
• The glass wood overlay panel should not weight more than
10 pounds.
The following instructions cover installing a solid wood overlay or
glass wood overlay panel and handle to a door or drawer.
IMPORTANT NOTE: Contact the factory or visit www.
bringperlickhome.com for full size wood overlay panel layouts.
Once on the site, select 'Service and Support' from the top menu
bar and click on 'Wood Overlay Templates' . Take care in chosing the
correct template for your specific model.
IMPORTANT NOTE: You must install optional lock and handle
PRIOR to mounting the wood overlay onto the door frame.
Panel drawings:
Refer to Figure 10 for solid wood overlay panel (page 12).
Refer to Figure 11 for glass wood overlay panel (page 13).
Refer to Figure 12 for drawer wood overlay panel (page 14).
Operation & Installation Manual
Signature Series (HP15 model)
Door Lock Installation (optional)
When installing to wood overlay, perform lock installation before
mounting wood overlay to door.
1. See Figure 9 (below), attaching mounting bracket to wood
overlay.
2. Insert lock body and attach with nut.
Lock installation drawings:
Refer to Figure 13 for Lock Installation on solid wood overlay panel
(page 15).
Refer to Figure 14 for Lock Installation on glass wood overlay panel
(page 16).
Refer to Figure 15 for Lock Installation on drawer wood overlay
panel (page 17).
Figure 9 - Lock installation
Lock body
Mounting bracket
Nut
Lock strike
Lockwasher
Screw
Lock bracket
11