Exmark Ultra Vac QDS Operator's Manual page 16

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.7.2 Door closing: The closing of the door is controlled by the two hinge links (Figure
3.7.3 Door opening: After adjusting the hinge links for door closing, the hinge stops
10 – A). The length of the hinge links can be changed to provide complete
closing of the door and reasonable force on the handle to latch or unlatch the
door. Lengthen the links to reduce the force. Shorten the links to increase the
force. The left and right sides must be approximately equal. With the door
closed, both links should be slightly tight to minimize rattling.
(Figure 10 – B) can be adjusted to obtain maximum door opening. The stop
plates should be adjusted so that the door link contacts them when the upper tube
of the door frame is within .25" (6.4 mm) ± .125" (3.2 mm) from the lower lip of the
molded hood. Both left and right stops must make contact when the door link arm
is at this position.
www.mymowerparts.com
FIGURE 9
FIGURE 10
11