Subaru 2002 IMPREZA Service Manual page 2779

B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Make sure that the glass stay is placed securely
in sash.
2) Adjust the front door glass. <Ref. to GW-13, AD-
JUSTMENT, Front Door Glass.>
Tightening torque:
Refer to COMPONENT in General Descrip-
tion. <Ref. to GW-4, FRONT DOOR GLASS,
COMPONENT, General Description.> and
<Ref. to GW-3, FIXED GLASS (WAGON),
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
Before adjustment, ensure that all adjusting bolts of
stabilizer, upper stopper, and sash are loose and
door glass is raised so that it is in contact with
weatherstrip.
1) Temporarily tighten one adjusting bolt on one
side of rear sash at the midpoint of slotted hole in
the inner panel.
2) Temporarily tighten the regulator B-channel in a
position at the top of slotted hole.
3) Lower the door glass 10 to 15 mm (0.39 to 0.59
in) from fully closed position. While applying out-
ward pressure of 45.0±4.9 N (4.6±0.5 kg, 11.0±1.1
lb) (F) to upper edge of glass above midpoint of two
outer stabilizers, press the inner stabilizer at pres-
sure of 10±5 N (1.0±0.5 kg, 0.2±0.1 lb) to the glass,
then secure it.
FRONT DOOR GLASS
4) For adjustment of clearance between front glass
and center pillar cover, loosen the nuts (A), and
move the glass sash back and forward until clear-
ance becomes the value shown.
5) For adjustment of upper and lower ends of cen-
ter pillar, loosen the adjusting nut (A) of B-channel
(B).
G5M0421
GW-13
GLASS/WINDOWS/MIRRORS
12 (0.472)
A A
Unit: mm (in)
BO0265
12 (0.472)
A-A
BO0388
BO0388
B5M0729A