Subaru 2002 IMPREZA Service Manual page 2427

16) Install the dust cover.
(1) Dust cover
17) Apply a coat of grease to the sliding surface of
seat pad, sleeve and seating surface of spring, and
then insert sleeve into steering body.
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw and install on
steering body.
(1) Seat pad
(2) Sleeve
(3) Spring
(4) Adjusting screw
(5) Lock nut
18) Extend the rack L beyond pinion side of steer-
ing body.
On condition
L: Approx. 40 mm (1.57 in)
19) Tighten the adjusting screw until it will no long-
er tighten.
STEERING GEARBOX [RHD MODEL]
S4M0409A
S4M0274A
PS-65
POWER ASSISTED SYSTEM (POWER STEERING)
20) Install the tie-rod and lock washer into rack
end.
Tightening torque:
78 N·m (8.0 kgf-m, 57.9 ft-lb)
(1) Tie-rod
21) Bend the lock washer.
CAUTION:
Be careful not to scratch the rack when bending
lock washer.
(1) Lock washer
22) Loosen the adjusting screw.
23) Move the rack shaft fully to right and left several
times.
S4M0150B
S4M0599A