Table of Contents
Advertisement
STEP
B1
STEP
B2
NOTE: Section B applies to the In-Ceiling AutoDome.
Carefully remove the G3 AutoDome
Save all packing material, as it can be used for setting
up the camera and for transporting the dome.
If the item appears to have been damaged in ship-
ment, replace it properly in its carton and notify the
shipper. If any items are missing, notify your Philips
Communication, Security & Imaging Sales
Representative or Customer Service Representative
at the location nearest you:
The Americas: 1 800 326 3270
Europe & Middle East: 31 40 278 1222
Asia Pacific Region: 65 350 1859
or visit our Web site at www.philipscsi.com.
To use FastAddress, skip to Step B3. Otherwise, set
the address switch as shown. Setting address selector
to 0000 (Not Recommended), responds to all mes-
sages regardless of address; otherwise, the unit will
only respond to commands issued for that address.
If you are using RS-232 Communications:
The unit is shipped with the RS-232 Baud Rate set to
9600.This rate can be changed with dip switch.
The following settings pertain to AutoDome versions
2.00 and newer:
Switch 1 ON: RS-232 Baud rate = 19.2 K
Switch 2 OFF: RS-232 Baud rate = 9600
For versions prior to 2.00, use the following settings:
Switch 1 ON: RS-232 Baud rate = 9600
Switch 2 OFF: RS-232 Baud rate = 19.2 K
21
®
from the box.
Hide quick links:
Advertisement
Table of Contents
