Philips G3 EnviroDome Instruction Book page 47

Figure 4. Preset tour period adjust
Record/Playback Tours
You can record two independent macros (series of commands),A & B.
These macros can last up to several hours each, although tours involving
constant commands will only last for minutes. While recording, the On-
Figure 5. Recording
Changing the Auto Pan and Auto Scan speeds
The Auto Pan and Auto Scan speeds (Fig. 6) can be adjusted using the
"On 14 Enter" command. Use the joystick to adjust the speed. It is helpful
for the Pan or Scan to be active when you enter the "adjust" mode, so you
can see the speed change.
Figure 6. Auto Pan/Auto
Speed adjust
Setting the Preset Tour period
To change the length of time the AutoDome
waits between Presets during a Preset Tour,
type "On 15 Enter" and adjust using the
joystick (Fig. 4).
Screen display (Fig. 5) indicates how much
memory is left. To begin recording on A, type
"On 100 Enter. " The G3 will now record all
camera activities until you end the recording
with "Off 100 Enter. " Once you have recorded
on A, B is available by using the "On/Off 101
Enter" command. Playback can be continuous
(On 50 Enter) for A, (On 52 Enter) for B or
"one shot" (On 51 Enter) for A, (On 53 Enter)
for B.
For additional information or to speak
to a representative, please contact the
Philips Communication, Security &
Imaging location nearest you:
The Americas: 1 800 326 3270
Europe & Middle East: 31 40 278 1222
Asia Pacific Region: 65 350 1859
or visit our Web site at
www.philipscsi.com.
II