Table of Contents
Advertisement
c. In the scenario where a camera is being moved,
the dome may already have an address, therefore
it will not respond to the "On-999-Enter" com-
mand. In this case, you must use the "On-998-
Enter" command to readdress the camera, then
follow the instructions on the screen.
d.There will be a visual confirmation that the
address was set.
2. Clearing the address of a camera (causing the
address of the camera to revert back to the
address set by the thumbwheel):
a. Enter the FastAddress mode using either
method as described above and follow the
instructions on the screen (see Figure FA2).
b.At the end of the FastAdress mode, press "Off-
1-Enter" to clear the address.
c.There will be a visual confirmation that the
address was cleared. Use the "On-997-Enter"
command to check/confirm camera addresses.
For example, if referring to Camera 3, press
"Camera-3-Enter," then "On-997-Enter." This
will cause all cameras to briefly display their
addresses.
FastAddress is stored to nonvolatile memory and will
not change if power is removed or factory defaults
are restored ("Set-899-Enter").
FastAddress
Switch Address:
FastAddress:
To change or clear the
FastAddress.
Press:
ON – 26 – ENTER
Iris:
Return
Figure FA1
To enter the new address
0
Not Set
camera number matches
the new address, then
To clear current address
Press: OFF – 1 – ENTER
Iris:
32
FastAddress
ensure the keyboard
Press:
ON – 1 – ENTER
Return
Figure FA2
Hide quick links:
Advertisement
Table of Contents
