Advertisement
I. OPERATION
Place Scale on a horizontal flat surface.
1. Press [ON/OFF] key.
2. Wait until "0.0" is displayed.
3. Put the object(s) on the weighing platform.
4. Using the [MODE] key, you can switch between the
weighing units.
II. TARE WEIGHING
1. Turn on scale as described above.
2. Place the "tare item" on the platform.
3. Press [TARE] and wait until "0.0" is displayed.
4. Add the "net-weight-item".
III. CALIBRATION
Calibration is NOT required before first use. Only
calibrate if scale is not weighing properly.
**Make sure you use the correct calibration weight for
your scale or the calibration will not be accurate**
BLADE-50:
BLADE-400: 400g calibration weight
BLADE-550: 500g calibration weight
BLADE-1000: See section IV.Blade1000
1. Turn ON the scale.
2. Press and hold the [MODE] key until "CAL" is dis-
played. Release the [MODE] key.
3. Press [MODE] again. Now the display will read
"CAL" and the required calibration weight will flash 3
50g calibration weight
Calibration Procedures
Advertisement
