KYMCO Sento 50 Owner's Manual page 47

MAINTEN ANCE
4. After cleaning, rinse the scooter thoroughly with plenty of
clean water. This rinsing is required to remove detergent
residue which can corrode alloy parts.
5. Dry the scooter and then start the engine, allowing it to run
for several minutes.
6. Test the brakes before riding the scooter . Several applica-
tions of the brakes may be necessary to restore normal brak-
ing performance.
NOTE: Due to water on the brake components, braking
efficiency may be temporarily impaired immediately after
washing the scooter. Anticipate longer stopping distances
to avoid a possible accident.
Finishing touches:
After washing your scooter , consider using a commercially-
available spray cleaner/polish or a quality liquid or paste wax
to enhance and protect the paint's finish. Use only a nonabra-
sive polish or wax made specifically for scooters, motorcycles,
or automobiles. Apply the polish or wax according to the in-
structions on the container .
Removing r oad salt
The salt used in some communities to prevent road icing can
become very corrosive to your scooter . Wash your scooter as
soon as possible if it comes in contact with road salt (or sea
water).
1. Clean the scooter using cool water (see page 44). Do not
use warm water; as this will increase the corrosive effect of
the salt.
2. Dry the scooter and protect painted and metal surfaces
with wax or polish.
Painted alumin um wheel maintenance
Even if protected by paint, aluminum may corrode from con-
tact with dirt, mud, or road salt. Clean the scooter's wheels
with a wet sponge and mild detergent. Avoid stiff brushes, steel
wool, or cleaners containing abrasives or chemical compounds.
After washing, rinse with plenty of water and dry with a clean
cloth . Apply touch-up paint to the wheels where damage has
occurred.
Exhaust pipe maintenance
The exhaust system is stainless steel, but it can become stained
by oil or mud. If necessary , remove heat stains with a liquid
kitchen-counter abrasive.
45