Hammond B-3 Owner's Manual page 85

4. SPEAKER
This sets the type of the virtual speaker.
RotSmall RotSmall: A small Leslie speaker represented by Leslie 145 RotSmall
RotSmall RotSmall
RotLarge: A large Leslie speaker represented by Leslie 122 RotLarge RotLarge
RotLarge RotLarge
Station Station: A stationary speaker represented by Hammond PR-40 Station Station Station
5. CHORALE SPEED - HORN
12. CHORALE SPEED - BASS
Here the Speed of the virtual Rotor is set for Chorale mode.
The setting range is 0, 24 - 318 rpm. It does not rotate at 0.
6. TREMOLO SPEED - HORN
13. TREMOLO SPEED - BASS
Here the Speed of the virtual Rotor is set for Tremolo mode.
The setting range is 0, 24 - 453 rpm. It does not rotate at 0.
7. HORN LEVEL
14. BASS LEVEL
The Volume of each virtual Rotor is set. The setting range is 0 to -12dB.
8. RISE TIME - HORN
15. RISE TIME - BASS
Here the Time is set for the Rotor to reach the maximum Tremolo Speed, when
changing from Chorale or Stop to Tremolo mode. The setting range for the Horn
Rotor is 0.2 - 5.0s, and that for the Bass Rotor is 0.5 - 12.5s.
9. FALL TIME - HORN
16. FALL TIME - BASS
Here the Time is set for the virtual Rotor to reach the minimum Chorale speed,
when changing from Tremolo to Chorale mode. The setting range for the Horn
Rotor is 0.2 - 5.0s, and that for the Bass Rotor is 0.5 - 12.5s.
10. BREAK TIME - HORN
17. BREAK TIME - BASS
Here the Time is set for the virtual Rotor to stop, when changing from Tremolo
mode to Stop mode. The setting range for the Horn Rotor is 0.2 - 5.0s, and that for
the Bass Rotor is 0.5 - 12.5s.
11. HORN CHARACTER
Here the Tone of the Horn Rotor is set.
"FLAT" has no boost or cut in freqencies, and the others are have "peaks" in vari-
ous tonal ranges.
18. MIC - ANGLE
This is the parameter to set the virtual LOCATIONS of the two "microphones" for
the virtual Leslie Speaker.
The ANGLE decides the distance between the two virtual mikes.
The setting range is 0 - 180 degrees. Farther settings exhibit more stereophonic
characteristics.
19. MIC - DISTANCE
This is the parameter to set the DISTANCE between the virtual Leslie Speaker and
the "microphones".
The setting range is 0.3 - 2.7m. The more the value increases, the less intense the
sound.
NOTE: When you operate the parameters 2 - 19, the setting range will be lost after the
power is switched off, if you do not do the recording operation of the next para-
graph.
85
Setting the Parameters