Speaker Layout; Connecting A Tv - JVC XV-THS3 Instructions Manual

Dvd digital cinema system
Hide thumbs Also See for XV-THS3:
Table of Contents

Advertisement

Connections

Speaker layout

Center speaker
Front left
speaker
Surround left
speaker
NOTE
• Although the satellite speakers and the subwoofer are magnetically
shielded, the TV screen may appear mottled. In this case, keep
enough distance between the speakers and the TV.
• The speakers are magnetically shielded to avoid color distortions on
TVs. However, if not installed properly, it may cause color
distortions. So, pay attention to the following when installing the
speakers.
- When placing the speakers near a TV set, turn off the TV's
main power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV's main
power switch again.
Some TVs may still be affected even though you have followed
the above. If this happens, move the speakers away from the TV.
• Place the satellite speakers on a flat and level surface.
• Be sure to place the subwoofer to the TV's right. If you place the
subwoofer to the TV's left, keep sufficient distance between them to
prevent the TV screen from appearing mottled.
9
Do not connect the power cord until all other connections have been made.
• Distortion of picture may occur when connecting the TV via a
Front right
• You need to set "MONITOR TYPE" in the PICTURE menu
speaker
7 To connect a TV equipped with the component video
Subwoofer
Surround right
speaker
NOTE
• If your TV supports progressive video input, you can enjoy a high
• If the component video input jacks of your TV are of the BNC type,
• The component video signals can be output only when you select
7 To connect a TV equipped with the S-VIDEO and/or
NOTE
• Select the appropriate scan mode according to your TV. (See page

Connecting a TV

VCR, or to a TV with a built-in VCR.
correctly according to the aspect ratio of your TV. (See page 32.)
input jacks
Center unit
Component video cord (not supplied)
quality picture by setting the progressive scan mode to active. (See
page 15.)
use a plug adapter (not supplied) to convert the pin plugs to BNC
plugs.
"DVD" as the source to play. (See page 14.)
the composite video input jacks
Center unit
Composite video cord
(supplied)
S-VIDEO cord (not supplied)
15.)
TV
To component
video input
TV

Advertisement

Table of Contents
loading

This manual is also suitable for:

Th-s3Sp-ws3Sp-ths3f

Table of Contents