Connecting The Speakers - JVC RX-F31S Instructions Manual

Connecting the speakers

Do not connect the AC power plug to the wall outlet until all connections are completed.
Speaker Layout Diagram
C
L
LS
Powered
subwoofer
(SW)
Right front speaker
Connecting the speakers
Turn off all components before making connections.
1 2
1
Twist and remove the insulation at the end of each
speaker cord.
2
Press and hold the clamp of the speaker terminal
(1), then insert the speaker cord (2).
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
3
Release the finger from the clamp.
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
6
SW
R
RS
SB
(R)
Left front speaker
3
1
2
220V 110V
230 -
240V 127V
Center speaker (C)
RIGHT
AV
SUB-
COMPU
WOOFER
LINK-III
OUT
(L)
Right surround
speaker (RS)
Connecting the powered subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord
with RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or a subwoofer, set the
speaker setting information properly to obtain the best possible
surround effect. For details, see pages 16, 17, and 21 to 23.
NOTE
You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
CAUTION:SPEAKER
IMPEDANCE 6 – 16
FRONT CENTER SURROUND SURROUND
BACK
LEFT RIGHT LEFT
SPEAKERS
Surround back
speaker (SB)
Left surround
speaker (LS)