Required Wall Console Installation; Series Ii Wall Consoles With White Button - Overhead door Standard Drive 650 Operation & Maintenance Manual

Required Wall Control Installation
In your carton you will find one of the following wall controls.
NOTE: Wall consoles from other manufactures may not work with these openers. Use only the wall console provided with this unit. See warning.
SERIES II WALL CONSOLE WITH WHITE BUTTONS
If you encounter a problem, check:
• White wire connected to terminal "W. "
• Striped wire connected to terminal "B/W. "
FEATURES
Indicator Light
Large white button ail display Red when wall console is properly
wired and Sure-Lock™ is OFF. When Sure-Lock™ is ON, this light is off.
Open/Close Button
Use this button to open or close garage door. When Sure-Lock™ is
ON the Open/Close button will CLOSE the door only.
NOTE: Constant button pressure in the CLOSE mode will
override STB fault in the powerhead and close door.
Independent Light Control Button
Use this button to powerhead lights ON. Powerhead lighting will
remain ON until this button is pressed again or a door action has been
completed.
Sure-Lock™ Button
When Sure-Lock™ is ON, and the door is closed, the powerhead cannot
be activated by the wall console or a remote.
•
Press and release to activate Sure-Lock™ (red light goes off).
•
Press and release to turn Sure-Lock™ OFF (red light goes on).
WALL BUTTON
This is a lighted wall button. Press once to move the door.
If the button is not lighted, check:
•
White wire connected to terminal "W"
•
Striped wire connected to terminal "B"
@ www.overheadhoor.com
5