Remote Control Programming - Overhead door Standard Drive 650 Operation & Maintenance Manual

Remote Control Programming

REMOTES
NOTE: THE REMOTE CONTROLS INCLUDED WITH THIS OPENER, HAVE
BEEN PRE-PROGRAMMED AT THE FACTORY FOR YOUR CONVENIENCE.
NOTE: The following instructions are for remote control transmitters
purchased separately in addition to those provided with this opener, but
can also be used if any remote(s) may require re-programming.
NOTE: You have 30 seconds to execute each step. If you see two
flashing red LEDs on the Powerhead, you have run out of time and
must go back to the beginning of the step and start over. You can
restart as many times as necessary to complete each step.
NOTE: Do NOT hold Remote too close to the Powerhead when
programming Remote buttons.
NOTE: Each button on each Remote must be programmed separately,
following these steps. *
10
The Remote is now programmed.
Repeat as necessary for additional Remotes.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR IS READY TO USE!
For Car2U and HomeLink, park the car outside the garage
NOTE:
with the ignition key in the "Accessory" position. Follow the Car2U or
HomeLink instruction included in your vehicle manual to set the button
in the car to Overhead Door mode.
NOTE: Your older CodeDodger remote transmitters will operate this new
model opener after programming, using the procedure on this page.