Configuring Per-Port Transmit And Receive Modes; Configuring Basic Lldp Per-Port Advertisement Content - ProCurve 6400cl Management And Configuration Manual

ProCurve(config)# setmib lldpnotificationinterval.0 -i 60
lldpNotificationInterval.0 = 60

Configuring Per-Port Transmit and Receive Modes

These commands control advertisement traffic inbound and outbound on
active ports.
Syntax lldp admin-status < port-list > < txonly | rxonly | tx_rx | disable >
With LLDP enabled on the switch in the default configuration,
each port is configured to transmit and receive LLDP packets.
These options enable you to control which ports participate in
LLDP traffic and whether the participating ports allow LLDP
traffic in only one direction or in both directions.
txonly: Configures the specified port(s) to transmit LLDP pack­
ets, but block inbound LLDP packets from neighbor devices.
rxonly: Configures the specified port(s) to receive LLDP packets
from neighbors, but block outbound packets to neighbors.
tx_rx: Configures the specified port(s) to both transmit and
receive LLDP packets. (This is the default setting.)
disable: Disables LLDP packet transmit and receive on the
specified port(s).

Configuring Basic LLDP Per-Port Advertisement Content

In the default LLDP configuration, outbound advertisements from each port
on the switch include both mandatory and optional data.
Mandatory Data. An active LLDP port on the switch always includes the
mandatory data in its outbound advertisements. LLDP collects the mandatory
data, and, except for the Remote Management Address, you cannot use LLDP
commands to configure the actual data.
■ Chassis Type (TLV subelement)
Chassis ID (TLV)
■
■ Port Type (TLV subelement)
■ Port ID (TLV)
Remote Management Address (TLV; actual IP address is a subelement that
■
can be a default address or a configured address)
Configuring a Remote Management Address for Outbound LLDP
Advertisements. This is an optional command you can use to include a
specific IP address in the outbound LLDP advertisements for specific ports.
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
15-41