Operating Rules - ProCurve 6400cl Management And Configuration Manual

Procurve switches e.10.02 (series 5300xl) l.10.xx (series 4200vl) m.08.73 (series 3400/6400cl)
Table of Contents

Advertisement

Port Traffic Controls
Jumbo Packets on the Series 3400cl and Series 6400cl Switches
14-28

Operating Rules

Required Port Speed: The 3400cl/6400cl switches allow inbound and
outbound jumbo packets on ports operating at speeds of 1 gigabit or
higher. At lower port speeds, only standard (1522-byte or smaller) packets
are allowed, regardless of the jumbo configuration.
Flow Control: Disable flow control (the default setting) on any ports or
trunks through which you want to transmit or receive jumbo packets.
Leaving flow control enabled on a port can cause a high rate of jumbo
drops to occur on the port.
Switch Meshing: If you enable jumbo traffic on a VLAN in a 3400cl or
6400cl switch, then all meshed ports on the switch will be enabled to
support jumbo traffic. (On a given meshed switch, every meshed port
operating at 1 Gbps or higher becomes a member of every VLAN config­
ured on the switch.)
GVRP Operation: A VLAN enabled for jumbo traffic cannot be used to
create a dynamic VLAN. A port belonging to a statically configured, jumbo-
enabled VLAN cannot join a dynamic VLAN.
Port Adds and Moves: If you add a port to a VLAN that is already
configured for jumbo traffic, the switch enables that port to receive jumbo
traffic. If you remove a port from a jumbo-enabled VLAN, the switch
disables jumbo traffic capability on the port only if the port is not currently
a member of another jumbo-enabled VLAN. This same operation applies
to port trunks.
Jumbo Traffic Sources: A port belonging to a jumbo-enabled VLAN can
receive inbound jumbo packets through any VLAN to which it belongs,
including non-jumbo VLANs. For example, if VLAN 10 (without jumbos
enabled) and VLAN 20 (with jumbos enabled) are both configured on a
switch, and port 1 belongs to both VLANs, then port 1 can receive jumbo
traffic from devices on either VLAN. For a method to allow only some
ports in a VLAN to receive jumbo traffic, refer to "Operating Notes for
Jumbo Traffic-Handling" on page 14-32.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6400cl and is the answer not in the manual?

This manual is also suitable for:

4200vl3400cl5300xl

Table of Contents