Table of Contents
Advertisement
Access Controller xl Module for the Series 5300xl Switches
Using 5300xl Features with the Access Controller xl Module
Note
12-8
5300xl switch ports that are not used by the Access Controller xl Module (that
is, they are not downlink client ports, or members of client VLANs) continue
to operate as regular 5300xl ports. Their operation is not affected.
The table below presents the 5300xl switch features that are not supported
for use with an ACM module.
Table 12-1. 5300xl Switch Features Not Supported on an ACM
Feature
802.1X
ACL
Configuring IP
Addresses
DHCP/DHCP Relay
IP Helper Address
Flow Control
GVRP
IGMP
Interface Monitoring
(Port Mirroring)
Interface Provisioning:
Speed
Duplex
Flow-Control
Auto-MDIX mode
'x' indicates that the feature is not supported.
Explanation
x
x
x
Not allowed.
x
Has no effect if assigned. Warning issued
x
Not allowed.
x
Not allowed.
x
Not allowed.
Not supported across an ACM.
x
x
x
x
GVRP cannot be enabled on an uplink,
downlink, or downlink client port.
A port in a GVRP VLAN cannot be added to
a client VLAN.
If GVRP is enabled on a port when it is
added to a client VLAN, it is disabled.
x
x
x
IGMP cannot be enabled on client
VLANs.As a result, it cannot be enabled on
downlink client ports.
x
x
x
Cannot be used as a monitoring port.
x
x
Fixed at 1000Mbps.
x
x
Fixed at Full-Duplex.
x
x
Not allowed.
x
x
Not allowed.
Advertisement
Chapters
Table of Contents
Troubleshooting
