[Ftp Settings] - [Ftp Server Settings]; [Ftp Settings] - [Ftp Tx Settings] - Konica Minolta bizhub C3850 User Manual

1.5 Available operations in Administrator mode

[FTP Settings] - [FTP Server Settings]

To display: Administrator mode - [Network] - [FTP Settings] - [FTP Server Settings]
To use application software with which the FTP server of this machine is used to communicate, configure the
FTP server.
Item
[FTP Server]
[Port Number]
[Command Prohibit]
[PORT Command En-
hanced Security]

[FTP Settings] - [FTP TX Settings]

To display: Administrator mode - [Network] - [FTP Settings] - [FTP TX Settings]
Configure settings to enable use of the FTP transmission function on this machine.
Item
[FTP TX]
[Connection Timeout]
[Proxy Server Address]
[Proxy Server Port
Number]
bizhub C3850/C3350
Description
Select whether or not to use the FTP server function of this machine.
[Enable] is specified by default.
If necessary, change the FTP server port number.
[21] is specified by default.
Select a command to deny a receiving job from an FTP client when using the
FTP server of this machine.
Set this option to return an error when a PORT/EPRT command or PASV/EPSV
command is sent from an FTP client to this machine.
[Allow] is specified by default.
Select whether or not to enable the security of this machine against FTP
bounce attacks. This option is not available if [Command Prohibit] is set to
[PORT/EPRT].
When a PORT/EPRT command is sent from an FTP client, the data connection
is established only if both of the following conditions are satisfied:
• A port number less than 1024 is not specified.
• The IP address specified by the command is same as that specified when
a control connection is established.
[Enable] is specified by default.
Description
Select whether or not to use the FTP transmission function of this machine.
Selecting this option sends the scanned original data to the FTP server.
[Enable] is specified by default.
If necessary, change the time-out time to limit a communication with the FTP
server.
[60] sec. is specified by default.
To access to the FTP server via a proxy server, enter the proxy server address.
Use one of the following formats.
• Example of host name entry: "host.example.com"
• Example of IP address (IPv4) entry: "192.168.1.1"
• Example of IP address (IPv6) entry: "fe80::220:6bff:fe10:2f16"
If necessary, change the proxy server port number.
[21] is specified by default.
1
1-61