68
Adapter plate
Figure 11. Typical full frame inner packaging with ramp
6. Remove the accessory boxes, ramp, and corner pads.
7. Using a 6mm hex and 19mm wrench, remove the adapter plates that
anchor the cabinet to the pallet.
8. Remove the poly bag covering the cabinet.
9. Following the instructions provided on the wooden ramp, attach the
ramp to the pallet and roll the cabinet onto the floor.
10. Visually check the unit for any damage.
HP StorageWorks XP12000 Disk Array Site Preparation Guide
Poly bag
Corner pads
Wooden ramp
Accessory box