Machine With Card Programmer; Automatic Unit - Electrolux FLE120 Service Manual

Service
Manual

Machine with card programmer

Y1 Switch ON. Switch acts as main switch for
Fig.
operating circuit.
1
Y2 Switch RESTART. Switch restarts
programme after ''programme stop'' and stops
the advance of the buzzer.
Y3 Swtich GENTLE ACTION, provides gentle
action during wash.
Y4 Switch DRAIN opens the drain valves.
Y5 Switch HOT WATER flushes hot water in the
machine.
Y6 Switch COLD WATER flushes cold water in
the machine.
Y7 Switch DETERGENT. Causes detergent in
compartment 1 to be flushed in to the
machine.
K2 Relay for wash motor – distribution speed.
K3 Relay for wash motor – wash speed.
K4 Relay for drain.
K5 Relay for restart.
K6 Relay for unbalance cut out.
K9 Extraction relay, low speed
K10 Extraction relay, high speed
K11 Extraction relay, high speed (not used for
380/220 V motor)
X1 Delay unit – relay circuit which delays the
switching off of the doorlock's electromagnet
from 20 to 30 seconds. This makes it possible
to open the door after the corresponding time
after the programme stop.
X3 Reverser – provides start impulses to
reversing and extraction giving programme
controlled drain and distribution respectively.
X4 Buzzer – to indicate programme stop.
X8 Timer relay – drain.
X9 Timer relay – extraction.
X10 Unbalance cut out.
N Level switch – pressostat to guard the water
levels. This is connected to the drain valve's
riser to the drum. The level switch also
prevents heaters coming on without water.
S, G, M, V, E, I, L and T are contact components
for quick connections of the different units to the

automatic unit.

9406
21. Automatic unit
1
21
2440
1