Rinses 1 To 3 - Electrolux FLE120 Service Manual

4

Rinses 1 to 3

Rinses 1-3 last for 4,5 minutes and are identical. Rinse 1 is described
here. The rinse starts with cold water inflow until high water level is
reached (peg 26 in track N and O removed).
The automatic card device stops advancing the programmed card at
peg 26 until the water level is reached. As the card must be punched
for the entire time advance is necessary. Tracks N and O are
removed for the required running time. The removal of these pegs
during the running time does not cause water to be flushing
continually, as this function is now controlled by the level check. The
absence of a peg is required in order to initiate a function and to
advance the automatic card device. When the water level and
temperature have been reached the running time of this card is 2,5
minutes peg 26 to 31 have been removed in tracks N and O).
The rinse ends with Drain for 1,5 minutes with Spin for the last half
minute peg 41 to 43 in tracks K and N peg 42 to 43 in track H
removed). Track K should always be progarmmed parallel with cam
H so that the water can drain, but as spinning should not take place
when the drum is filled with water, cam K (Drain) is programmed one
peg earlier than the spin, allowing the water to empty before the spin
starts.
Rinse 4
Rinse 4 lasts for 9 minutes and starts with inflow of cold water to high
level and detergent dispensing (fabric conditioner) from compartment
3 peg 53 in tracks E, N and O removed).
The advance of the programmed card stops at peg 53 until the water
level has been reached. As the card must be punched for the whole
time advance is required, tracks N and O are punched for the
appropriate time. The removal of these pegs during the running time
does not cause the water to flush continually, as this function is now
controlled by the level check. The absence of a journal is required in
order to initiate a function and to advance the automatic card device.
When the water level has been reached the running time of this card
is 3 minutes (peg 54 to 58 have been removed in tracks N and O).
Rinse 4 ends with Drain for 6 minutes peg 59 to 70 in track K
removed). When the drain has run for 0,5 minutes the spin starts and
lasts for 5 minutes peg 60 to 69 in track H removed). The first minute
of spin is slow and the remaining 4 minutes high speed. The spin
ends with distribution speed for 0,5 minutes. This is achieved through
clipping track K one after the last journal of the spin.
Completion
Completion of the washing process can be achieved through
punching peg 71 in track M (Programme Stop). A programme stop is
indicated by a buzzer and the yellow signal lamp in the restart button
lights up.
4
4. Programmes
Service
Manual
9406