Installation
For the installation of machines with optio-
nal equipment (such as the tilt function),
see also the section "Optional equipment"
at the end of this manual.
The washer extractor is supplied bolted in place
on a pallet and packaged in a delivery crate. In
some cases the machine may be supplied in wa-
terproof/dustproof packaging. The direction from
which the machine must be lifted and the machi-
ne centre of gravity are shown on the packaging.
Location and surface
The machine must not be sited over an open
floor drain. Check that the floor has an even
surface and is level. The floor must be capable of
withstanding the following: See "Technical data".
The following clearances are recommended:
• at least 1000 mm between the machine and
1
any wall behind it.
• at least 500 mm at each side, between the
side of the machine and a wall, or between
machines where these are side by side.
Mechanical installation
• Remove the packaging material. Remove the
2
machine's rear cover, side panels and lower
front panel.
• Remove the eight bolts securing the
3
machine's outer- and innerframe onto the
pallet.
Machine equipped with weight measurement
The load cells, which are fitted by the machine's
feet, are sensitive to knocks and impacts.
Installation
1
1 m
1000 mm
2
3
11
0,5 m
500 mm
5541
5542
5543