Lantronix SecureLinx Quick Start Manual page 7

S e c u r e L i n x M a n a g e m e n t A p p l i a n c e
CONFIGURING NETWORK SETTINGS CONTINUED...
Obtain from DHCP: Acquires IP address, subnet mask, and gateway from
the DHCP server. (The DHCP server may provide the gateway, depending on its setup.)
This is the default setting for Network Port 1. If you select this option, skip to step 3.
Obtain from BOOTP: Lets a network node request configuration information
from a BOOTP "server" node. Skip to step 3.
Specify: Requires you to assign a static IP address manually.The administrator
generally provides the IP address.
IP Address An IP address that will be within a valid range, unique to your
(if specifying)
network, and in the same subnet mask as your PC.
Note: Enter all IP addresses in dot quad notation.
Subnet Mask The network segment on which the SLM resides.
(if specifying)
3. To save your entries, click Apply. Clicking Apply commits these changes immediately.
To enter gateway information:
1. On the Network – Settings page, click the Gateways tab.The following page opens:
Network Settings - Gateway
10
Q u i c k S t a r t G u i d e
CONFIGURING NETWORK SETTINGS CONTINUED...
2. Enter the following:
Default IP address of the router for this network.
If this has not been set manually, any gateway assigned by
DHCP for Network Port 1 or Network Port 2 displays.
All network traffic that matches the Network Port 1
IP address and subnet mask goes out Network Port 1. All
network traffic that matches the Network Port 2 IP address
and subnet mask goes out Network Port 2.
If you set a default gateway, the SLM sends any network
traffic that does not match Network Port 1 or Network
Port 2 to the default gateway for routing.
DHCP Acquired Gateway assigned by DHCP for Network Port 1 or Network
(view only) Port 2. The default setting is None.
Precedence Indicates whether a gateway assigned by DHCP or the
default gateway takes precedence. The default setting is
DHCP Gateway. If you select DHCP Gateway, and both
network ports are configured for DHCP, the SLM gives
precedence to the Network Port 1 gateway.
3. To save your entries, click the Update button.
Note: You have configured the settings required to get the SLM up and running. To
complete the network configuration, see the SLM User Guide.
W W W . L A N T R O N I X . C O M
11