Snap Disc Replacement; Baffle Removal - Quadra-Fire 31I-ACC Owner's Manual

C. Snap Disc Replacement
1. The snap disc bracket assembly is located on top of the
blower housing in the center. Figure 23.1.
2. Remove the 4 hex head bolts using a 5/32 Allen wrench
from the blower housing and pull the housing towards you.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 23.2.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
6. Re-attached the blower housing to the appliance.
Snap Disc
Figure 23.1 Snap Disc Location
Snap Disc
Magnet
Figure 23.2
October 22, 2013
D. Baffle Removal
1. Remove all ash from the firebox, and extinguish all hot
2. The baffle board has 2 pieces. With the ceramic blanket
3. It is easier to remove both baffle boards and ceramic
4. Re-install in reverse order. Be sure the baffle boards and
Figure 23.3
Spade
Connectors
Figure 23.4
7044-226
embers before disposal into a metal container.
still in place, slide one baffle piece over the top of other one
but still keep it all components inside the firebox. Figure
23.3.
blanket after the tube channel assembly has been partially
disassembled. Follow steps 1 through 4 on page 25 for
removal of the tube channel assembly. It is not necessary
to completely remove the tube channel assembly.
ceramic blanket are in their proper positions. Figure 23.4.
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
Ceramic Blanket
Baffle
3100-I ACC
Baffle
23