Kobalt SGY-APS41 User Manual page 27

CARE AND MAINTENANCE
Note:
Paint from Prime Tube" and before proceeding to "Removing Excess Paint from
High Pressure Spray Hose".
Removing Excess Paint from High Pressure Spray Hose
1. Make sure safety lock is in locked position.
Note: Remove spray guard (J), single seal tip (M), and spray tip (L). Unscrew safety screw at base
of handle housing using hex key (R) to release handle housing, making the cleaning process
easier. Set aside for additional cleaning (see "Cleaning Sprayer and Components Before
Storage").
2. Fill clean water bucket and turn prime spray valve switch (H) to spray position.
3. Turn pressure control knob (F) to prime/clean position.
4. Unlock safety lock and place the spray gu
5. Depress trigger on spray gun BEFORE turning the machine on. This will decrease the possibility
of high pressure buildup in the system and any overspray.
6.
7. DO NOT release the trigger. The trigger should remain depressed, allowing water to continuously
spray.
8.
the system.
9.
STAGE 2: Cleaning Sprayer and Components Before Storage
1. Fill 5 gallon bucket with water.
2. Unscrew spray gun handle turning counterclockwise to
remove internal filter (E) from the handle as shown in
Figure 1.
3. (Spray guard should already be removed from spray gun
housing.) Using the pointed eject end of the spray tip (L),
press against the single seal tip (M) to remove it from the
spray tip housing as shown in Figure 2.
4. Thoroughly clean the single seal tip (M), the spray tip (L),
the internal filter (E), as well as the threading and head
of spray gun with cleaning brush (Q) removing any paint,
stain, or debris. Set components aside and allow to dry.
n o v r e w a s e t p a . l i
1
27
E
R
kobalttools.com