JVC HX-Z3 Service Manual page 6

HX-Z3
Removing the front panel assembly
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
1. Disconnect the card wires from connector CN44 and
CN870 on the main board on the right side of the
body. Remove the screw D attaching the wire from
extending from the underside of the front panel
assembly.
2. Disconnect the wire from connector CN701 on the
bridge board.
3. Cut the tie band.
4. Disconnect the wires from connector CN231 and
CN232 on the primary board on the left side of the
body and remove the band fixing the wire.
5. Remove the plastic rivet attaching the inner bar in
the center of the front panel assembly.
REFERENCE: Keep the plastic rivet for reuse.
6. Remove the three screws E
panel assembly at the bottom of the body.
7. Release the two joints a on the lower left and right
sides of the front panel assembly using a
screwdriver, and remove the front panel assembly
toward the front.
REFERENCE: Front panel need to be tilt a little bit as release
from bottom chassis.
1-6
Front panel assembly
(See Fig.6 ~ 9)
attaching the front
Inner bar
Bridge board
Bridge board
CN701
Joint a CN44
D
Fig.6
Primary board
CN231, CN232
Bottom chassis
Fig.7
Plastic rivet
Fig.8
CN701
E
Fig.9
Main board
CN870
CN922
Front panel assembly
Joint a
Front panel assembly
Band
Primary board
CN231, CN232
Front panel assembly