JVC HX-Z3 Service Manual page 17

Removing the try select switch board
1. Remove the two screws G retaining the tray select
switch board.
2. Disconnect the tray select switch board from
connector CN854 on the CD servo control board.
Removing the cam unit
Remove the CD loading mechanism assembly.
1. While turning the cam gear q , align the Paul r
position of the drive unit to the notch position on the
cam gear q .
2. Pull out the drive unit and cylinder gear .
3. While turning the cam gear q , align the Paul s
position of the select lever to the notch position on
the cam gear q .
4. Remove the four screws H retaining the cam
unit(cam gear q and cams R1/R2 assembly).
Fig.16
(See Fig.14)
(See Fig.15 ~17 )
Drive unit
Cylinder gear
Chassis assembly
CN854
CN851
CD servo
control board
Fig.14
Drive unit
r
Fig.15
H
Cams R1, R2 assembly
q
Cam gear
s
Select lever
Fig.17
Tray select
switch board
G
CN804
q
Cam gear
Cam unit
H
HX-Z3
1-17