Stay Arming; Instant Arming; Force Arming; Bypass Programming - Digiplex DGP2-641 System Manager's Manual

3.3

Stay Arming

Stay arming partially arms your system, permitting you to remain in your home or office by arming only the outer
zones (perimeter) of the protected area (i.e. doors and windows).
To Stay arm:
1. Enter your [
2. Press the [
3. If you have access to more than one area, select the area(s) you wish to Stay arm (refer to section 2.3 on page 2).
3.4

Instant Arming

This feature is the same as Stay arming except that there is no Entry Delay. Therefore, any armed zone that is
breached will immediately generate an alarm.
To Instant arm:
1. Enter your [
2. Press the [5] button.
3. If you have access to more than one area, select the area(s) you wish to Instant arm (refer to section 2.3 on
page 2).
3.5

Force Arming

Force arming allows you to quickly arm your system when zones are open. However, once the open zone is closed,
your system will then arm that zone as well.
To Force arm:
1. Enter your [
2. Press the [
3. If you have access to more than one area, select the area(s) you wish to Force arm (refer to section 2.3 on
page 2).
3.6

Bypass Programming

You can bypass certain zones when you arm the protected area(s). When a zone is bypassed, it will be ignored the
next time your system is armed. Once your area is disarmed, the system will unbypass the zone.
To Bypass a zone:
1. Enter your [
2. Press the [
3. Enter the zone number (i.e. 01, 02,...48), or use the [ ] and [ ] buttons and press [
want to bypass appears on the screen. If bypassed does not appear on the screen and the keypad emits a
rejection beep, you may not have access to bypass that zone.
4. Repeat step 3 until all zones you want to bypass have been selected.
5. Press the [
In order to bypass a zone, the following conditions must be met:
• The zone must have the Bypass option programmed by the installer.
• Your user access code must be programmed to enable the Bypass option.
• Your user access code must have access to the zone's Area Assignment.
• The zone's area must be disarmed before the zone can be bypassed.
Fire Zones cannot be bypassed.
3.6.1 Bypass Recall
Bypass Recall reinstates the zones that were bypassed the last time your system was armed.
To activate Bypass Recall:
1. Enter your [
2. Press the [
3. Press the [
4. Press the [
].
ACCESS CODE
] button.
STAY
].
ACCESS CODE
].
ACCESS CODE
] button.
FORCE
].
ACCESS CODE
] button.
BYP
] button to save and exit.
ENTER
].
ACCESS CODE
] button.
BYP
] button. Zones bypassed the last time your system was armed are bypassed.
MEM
] button to save and exit.
ENTER
] once the zone you
BYP
LCD Keypad 3