Trouble Display; Event Record Display - Digiplex DGP2-641 System Manager's Manual

7.0

Trouble Display

If your system experiences any problems, Trouble(s) [TRBL] to View will appear on the LCD screen. The
Trouble Display will only display the troubles that occur in the area(s) to which the keypad has been assigned.
Potential troubles have been sorted into eight groups. Only the troubles which are relevant to you are listed and
described below. If a trouble that is not described or listed below appears, contact your installer.
To View the Trouble Display:
1. Press the [
Heading with the trouble will appear on the screen.
2. Press the [ ] and [ ] buttons to scroll between the Groups experiencing a trouble.
3. Press the [
We strongly suggest that if any troubles occur, contact your installer immediately to have
your system serviced.
7.0.1 Group 1: System
Trouble [1]: AC Failure
The control panel has detected a power failure. This means that your system is running on the backup
battery. If this trouble occurs when your establishment is not experiencing a power failure, call your
installer for repairs.
Trouble [2]: Battery Trouble
The backup battery is disconnected, needs to be recharged, or replaced.
Trouble [5]: Bell Absent
The system has detected that the bell or siren is not connected.
7.0.2 Group 2: Communicator
Trouble [1]: TLM 1
The control panel is unable to access the main telephone line.
Troubles [2] to [5]: Fail to Communicate
The control panel tried all assigned telephone numbers and failed to contact the monitoring station.
Trouble [6]: Fail to Communicate PC
The control panel is unable to communicate with the WinLoad software.
7.0.3 Group 5: Zone Tamper
The zone(s) that was tampered with will be displayed on the LCD screen.
7.0.4 Group 6: Zone Low Battery
If a wireless device's battery needs to be replaced, the zone that is assigned to the device will be
displayed on the LCD screen.
7.0.5 Group 7: Zone Fault
A wireless device is no longer communicating with its receiver, or a connection or CleanMe
occurring with your smoke detectors.
7.0.6 Group 8: Clock Loss
The time and date have been reset to the default. This is the only trouble that we recommend that you
correct. Clock Loss [8] to Set will appear on the LCD screen after you press the [
Refer to section 8.3 on page 12 to set the time and date.
7.1

Event Record Display

The Event Record Display will record the user-initiated actions that occurred in your system as well as any alarms or
troubles (i.e. "Access Granted"). You will only be able to view the events that occurred in the area(s) assigned to
your user access code.
] button when Trouble(s) [TRBL] to View appears on the LCD screen. The Group
TRBL
] of the Trouble you wish to view.
NUMBER
TM
trouble is
] button.
TRBL
LCD Keypad 11