Adjustment Conditions - Ricoh G104 Service Manual

LASER EXPOSURE

Adjustment Conditions

If SP 2153-001 is set to 'on', then automatic line position adjustment is done at the
times shown below.
After process control is done
If SP 2153-002 is set to 'on', then the adjustment is done when these types of
process control are successfully done.
• Initial process control
• Interval process control
• No-use time process control
Initialization
If SP 2153-003 is set to 'on', then the adjustment is done when the main power is
turned on or the machine comes back from the standby mode, but only if one of the
following conditions occurs.
• At a set time after the previous adjustment. The default value is 360 minutes.
You can adjust the time with SP2153-013.
• When the temperature changed after a previous adjustment by more than a set
value. The default value is 5.
You can adjust the temperature change value with 2153-012.
Printing
If SP 2153-004 is set to 'on', then the adjustment is done when the machine gets
print job data, but only if one of the following conditions occurs.
• At a set time after the previous adjustment. The default value is 360 minutes.
You can adjust the time with SP2153-013.
• When the temperature changed after a previous adjustment by more than a set
value. The default value is 5 °C.
You can adjust the temperature change value with SP2153-012.
• When the magnification changed after a previous adjustment by more than a
set value. The default value is 1 %.
You can adjust the magnification change value with SP2153-015.
G104
CÓPIA NÃO CONTROLADA
6-32
CÓPIA NÃO CONTROLADA
SM