Bit Switch Programming - Ricoh G104 Service Manual

5.2.2 BIT SWITCH PROGRAMMING

Do not change the bit switches unless you are told to do this by the manufacturer.
1. Start the SP mode. The "Service" menu is shown.
2. Press the enter key two times.
3. To select a bit switch, press the up arrow key or the down arrow key.
4. Push the enter key.
5. Set the value with these keys:
• [Up] [Down]:Moves the cursor to one of the adjacent bits.
• [Escape]: Goes out of the program without saving changes.
• [Enter]:
Goes out of the program and saves changes.
The digit at the left [A] is bit 7 and the digit at
NOTE:
the right [B] is bit 0.
6. Push the escape key one or more times until the
menu "Service" is shown.
7. Select "End" and push the enter key.
SM
CÓPIA NÃO CONTROLADA
5-9
CÓPIA NÃO CONTROLADA
SERVICE MODE TABLE
[A] [B]
Sw#1 00000000
bit0 _
G104