Standard Configuration - Python 881 XP Installation Manual

3. S S e e l l e e c c t t t t h h e e r r e e c c e e i i v v e e r r c c h h a a n n n n e e l l . . Press and release the Valet®/Program switch the number of
times necessary to access the desired channel. Once you have selected a channel, press
and H H O O L L D D the Valet®/Program switch once more. The siren will chirp and the LED will blink
the number of times corresponding to the channel that has been accessed.
N N O O T T E E : : If adding a remote, a button must be taught to the unit in the Channel One or Channel
Five position prior to programming other channels.
C C H H A A N N N N E E L L N N U U M M B B E E R R
1
2
3
4
5
6
7
8
9
10
11
12
* * N N O O T T E E : : For Auto Learn Configurations, see Transmitter Configurations section of this guide.
C C h h a a n n n n e e l l s s T T w w o o , , T T h h r r e e e e a a n n d d N N i i n n e e : : Channels Two through Nine are used to assign the arm, disarm and panic func-
tions to separate buttons on the remote control. Teaching a button to Channel Two erases all information about
that remote from memory. Any auxiliary functions that are desired will have to be reprogrammed. Similarly, if the
remote is set up to use the separate arm, disarm and panic channels and a button from that remote is entered
into Channel Two, the remote will be erased from memory, and the system will only recognize the button that
was entered into Channel Two.
C C h h a a n n n n e e l l T T w w e e l l v v e e : : If any transmitter button from a known transmitter is programmed to Channel Twelve, all trans-
mitters will be erased from memory and will revert to the default feature settings. (See Features Menu section of
this guide.) This is useful in cases when one of the customer's transmitters is lost or stolen. This will erase any
lost or stolen transmitters from the system's memory. It can also be used to start from scratch if the transmitter
buttons were programmed incorrectly.
4. P P r r e e s s s s t t h h e e t t r r a a n n s s m m i i t t t t e e r r b b u u t t t t o o n n . . While H H O O L L D D I I N N G G the Valet®/Program switch, press the button
from the transmitter that you wish to assign to that channel. The unit will chirp indicat-
ing successful programming. It is not possible to teach a transmitter button to the system
more than once.
© 2005 Directed Electronics, Inc. Vista, CA
F F U U N N C C T T I I O O N N
Auto Learn Standard Configuration* * (default)
Arm/Panic On/Panic Off
Disarm/Panic Off
Silent Mode™/Remote Valet®/Trunk Release
Remote Start
Channel 4
Channel 5
Short Run/Turbo
Timer Mode
Arm/Disarm/Panic
Panic only
Delete all transmitters
W W I I R R E E C C O O L L O O R R
RED/WHITE
VIOLET/BLACK
WHITE/BLACK
3 3 7 7