Hitachi CP-X251 User Manual – Operating Manual page 5

Ports (See below.)
AUDIO IN3 L/R port (
(In the default setting, the
AUDIO IN3 L/R port is the audio
port for the VIDEO, S-VIDEO
and COMPONENT VIDEO
ports, however it is possible to
change the settings.
COMPONENT
13)
VIDEO ports (
Y
C /P
B B
C /P
R R
13)
VIDEO port (
13)
S-VIDEO port (
AUDIO IN2 port (
(In the default setting, the AUDIO
IN2 port is the audio port for
the RGB IN2 port, however, it is
possible to change the settings.
36)
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
Rear-Left side
AUDIO IN1 port (
(In the default setting, the AUDIO IN1 port is the audio
port for the RGB IN1 port, however, it is possible to
13)
change the settings.
RGB IN1 port (
36)
AUDIO IN3
Y R
RGB IN1
AUDIO IN1
C P
/
B B
L
AUDIO IN2
C P
/
R R
K
VIDEO
S-VIDEO
12)
Kensington lock slot
Power switch (
Vent (
12)
36)
12)
Restart switch (*) (
RGB IN2 port (
RGB OUT port (
RGB IN2 RGB OUT
AUDIO OUT
CONTROL
USB
USB port (
CONTROL port (
Part names
17)
14)
AC inlet (
Elevator button (
Elevator foot (
7)
58)
12)
12)
AUDIO OUT port
12)
(
Ports
12)
12)
9)
9)
5