Host Requirements (Only For Aculaser C900); Aidc Control - Epson AcuLaser C1900 Service Manual

EPSON AcuLaser C1900/AcuLaser C900

1.8 Host Requirements (Only for AcuLaser C900)

Windows
Table 1-51. Windows
CPU
Recommended Pentium II 450MHz
96MB or more
Host or higher
Minimum Pentium 233MHz
Requirements
Macintosh
Table 1-52. Macintosh
CPU
Recommended Host PowerPC G3 500MHz or higher
Minimum Requirements PowerPC G3 233MHz
Product Description
RAM HDD free space Interface
IEEE1284 ECP
500MB
USB
(for driver spool)
100BaseTx Ethernet
64MB
RAM Interface
128MB or more USB
AppleTalk
128MB
Host Requirements (Only for AcuLaser C900)

1.9 AIDC Control

Conditions for performing the AIDC control
When the power is ON or returned from the power saving after printing more
than 200 sheets following the previous AIDC control or the image stabilizing
control.
Conditions for performing the image stabilizing control.
When the power is ON or returned from the power saving after printing more
than 1000 sheets following the previous image stabilizing control.
Right after the Toners, the Photoconductor unit or the Transfer belt is
replaced.
After the Life counter is cleared following the replacement of the Fuser Unit.
(Because the 2nd Transfer roller which is replaced at the same time affects the
image quality.)
When Forced executions of the image stabilizing control are commanded.
When the environment such as humidity or the like has significantly changed
from the previous when the power is supplied.
Forced commands of the image stabilizing control
This is a function to perform the tone compensation control again when correct results
have not been obtained by the control.
1. The printer is not in error condition.
2. Remove papers from all paper feeders.
3. The image stabilizing control is performed after the cover which opens/closes
printer covers (the Front cover, the AB cover and the DM cover) is closed.
Revision B
82