Epson AcuLaser C1900 Service Manual page 134

EPSON AcuLaser C1900/AcuLaser C900
PLEASE WAIT (STATUS CODE: 1019)
Description
After executing Change Toner x, this message appears until the toner cartridge to
replace moves to the required position.
Treatment method
Once it moves to the required position, the message changes to "Replace Toner x".
Do not open printer cover during this message is displayed on the panel.
RESET TO SAVE (STATUS CODE: XXXX)
Description
During execution of a job, panel setting was changed in the panel setting mode.
Treatment method
The printer is recovered from this status by either of the following actions:
1. By pressing the Start/Stop button, the printer recovers from this status and
becomes ready for printing. However, change of panel setting is not reflected until
the JOB currently executed is completed.
2. By "Reset" or "Reset All", the printer becomes ready for printing and change of
panel setting is reflected immediately. However, the print data are all deleted.
WRITING ROM A (STATUS CODE: 1005)
Description
The printer is wiring data in the form overlay module.
Treatment method
Upon successful completion of writing, the printer returns to the original state.
WRITING ROM P (STATUS CODE: 1005)
NOTE: Not opened to users
Description
The printer is writing the program data in the program RUM module.
Treatment method
Upon successful completion of writing, the printer returns to the original state.
Troubleshooting
FORM FEED (STATUS CODE: 1008)
Description
By accepting the holding down of the Start/Stop button for more than two seconds
in the "printing impossible" state, the printer is forcedly printing the printable data
remaining inside and is ejecting the printed paper. After completion of paper
ejection, the printer remains in the "printing impossible" (offline) state.
WARMING UP (STATUS CODE: 1006)
Description
One of the READY messages. The engine is warming up. The LCD flashes
"Warming Up".
Treatment method
Upon completion of warming up, the printer becomes ready for printing.
CALIBRATING PRINTER (STATUS CODE: 1014)
Description
One of the READY messages. The printer is calibrating the engine.The LCD
flashes "Calibrating Printer".
Treatment method
Wait about one minute, until the printer recovers automatically.
COOLING DOWN (STATUS CODE: 1016)
Description
One of the READY messages. The printer is cooling down. The LCD flashes
"Cooling Down".
Treatment method
Wait about one minute, until the printer recovers automatically.
OFFLINE (STATUS CODE: 1001)
Description
The printer can prepare printing data or receive data, but does not start printing.
Treatment method
Pressing the Start/Stop button will restore the printer to the "ready to print" status.
Executing "Reset" or "Reset All" will delete all the printing data.
Status Display (AcuLaser C1900)
Revision B
134