Using The Meter Memory - Prodigy Autocode Owner's Manual

PRODIGY AutoCode® Blood Glucose Meter
Voice Speaks: "Blood glucose 108 mg/dL."
Repeat Feature: After test result is spoken, press
the "M" button to hear the result again.
This blood glucose result is automatically
stored in the meter memory. Turn the meter
off by removing the test strip. Discard the
used test strip carefully to avoid contamination.
Important: If you do not apply a blood
sample within (3) three minutes, the meter will
automatically turn off. You must remove the
test strip and re-insert it again to turn on the
meter and restart the test procedure.
Caution: If you cannot test due to a problem
with your testing supplies, contact Customer
Care at 1.800.243.2636. Failure to test could
delay treatment and/or lead to serious medical
conditions.
Owner's Manual
PRODIGY AutoCode® Blood Glucose Meter

Using the Meter Memory

The Prodigy AutoCode® meter stores a maximum
of the 450 most recent blood glucose test results
with date and time in its memory. It also provides
you with 7, 14 and 28–day averages of your blood
glucose test results. You can review the individual or
average test results by entering the memory mode.
STEP 1: Enter the Memory Mode
While the meter is turned off, press
and hold the "M" button to turn the
meter on. Press the "M" button again
to enter memory mode. The 7–day
average will appear, indicating that
you are in the memory mode.
If you continue to press the "M"
button, the 14 and 28–day averages
will appear in order. You can then review the last
450 individual test results in memory.
When using the meter for the first time or when
the memory has been deleted, "- - -" appears,
indicating there are no test results in the meter
memory. See Figure 35.
46
Owner's Manual
Figure 35
47