Haier AU482FIBHA Service Manual page 103

11
Outdoor fan mode :_1（low speed）,_2（med speed）,_3（high speed）
12
Temperature sensor ON display
13
Four-way valve switched on: ON： 1
14
Running mode selection
2 0
1
Dispatch line check
2
Dispatch line check
3
Cool trial run
4 Heat trial run: H --this function is preset
5 Swing trial run: _F--this function is preset
6
Indoor unit uniform start/stop
--this function is preset
7 Clean abnormal function: CL--this function is preset
8
Outdoor PMV1fully open、close function: fully open: FF, fully close: 00
9
Outdoor PMV2 fully open、close function: fully open: FF, fully close: 00
10
Indoor PMV fully open、close function：fully open: FF
11 Outdoor rated setting: -F
3 0—7
Indoor communication state: receiving normal： 1 receiving abnormal:
8 Display quantity of communicating indoor unit, e.g. : 6 shows that 6 indoor units
are working.
4 0—15 Indoor diagnosis code, no diagnosis code:
5 0—15 Indoor HP
new code:0 stands for 0.8HP, 1 stands for 1HP, 2 stands for 1.2HP,
3 stands for 1.5HP, 4 stands for 2HP, 5 stands for 2.5HP, 6 stands for 3HP, 7
stands for 4HP
Old code: 1 stands for 1HP,7 stands for 7HP
6 0—15 Indoor required capacity (decimalism) indoor P-CODE
7 0—15 Indoor PMV opening degree (decimalism)
8 0—15
Indoor saturation temperature (decimalism) -26.0—67.0（account according to
outdoor suction pressure PS）
9 1—16
Indoor sensor TA temperature（decimalism）-26.0—67.0
10 1—16
Indoor sensor TC2 temperature（indoor gas pipe） （decimalism）-26.0—100.0
11 1—16
Indoor sensor TC1 temperature（indoor liquid pipe） （decimalism）-26.0—100.0
12 1—16 Single cool trial run--this function is preset
13 1—16 Single heat trial run--this function is preset
Combination control with outdoor switches
Table 2
function summary
Cool trial run Indoor trial run in cooling
mode, the function is the
same as trial run with remote
controller,
which trials run fixes the temp.
difference as max. temp., and
send it to outdoor, the other
control is similar with normal.
Heat trial run Indoor trial run in heating
mode, the function is the
same as trial run with remote
controller,
which trials run fixes the temp.
difference
cooling： C, heating: H
cooling ：
heating ：
： C --this function is preset
：
Method of set, cancel
[set]
SW01"2", SW02"03", press SW04
than 2 seconds, after set of trial run success, LD
the indoor unit will always display –C until the function is
cancelled.
[cancel]
in trial run state, SW01"02", SW02"03", press
SW05
[set]
SW01"2", SW02"04", press SW04 for more than
4 seconds, after set of trial run success, LD will
the indoor unit always display –H until the function is cancelled.
[cancel]
as max. in trial run state, SW01"02", SW02"03", press
ON： 1，OFF：--
Four-way valve not switched on: OFF： _ _
CC --this function is preset
HH--this function is preset
run: 11/stop: 00 （ display -- after 3 minutes
--this function is preset
）
for more