Table of Contents
Advertisement
Acceleration/Deceleration time characteristics
The graph below shows the characteristics (representative values) of
acceleration/deceleration time based on a set speed of 2400 r/min (80 Hz).
30
20
10
0
Acceleration/deceleration-time
8.2 Switching the display mode
While the motor is running, the speed display shows the set motor speed in
frequency (Hz). You can change the display mode to show the set speed in number
of revolutions (r/min).
To do this, set DIP switch S5 (SW1) on the rear of the inverter to ON.
Factory setting: OFF (frequency display)
The speed shown on the speed display is the current setting. It is not the
Note
actual speed of the motor output shaft.
potentiometer graduation
10
Set S5 to ON
8 Various functions
– 45 –
Advertisement
Table of Contents
