Orientalmotor FE100 Operating Manual page 4

1 Introduction
EMC Directives
The EMC performance of the FE100/FE200 inverter has been measured in
accordance with "Example of inverter and motor installation/wiring" on p.26. The
user must measure the EMC performance of the final equipment with the
FE100/FE200 assembled into the equipment by referring to 5.4 "Installing and
wiring in compliance with EMC Directive" on p.24
WARNING FOR UL/cUL LISTING MARKING ON INVERTER
•
Use 60/75 °C CU wire only or equivalent.
•
Maximum surrounding air temperature 50 °C.
•
Install device in pollution degree 2 environment.
•
Tightening torque and wire range for field wiring terminals are listed as
below.
Power connection terminal and cable
Motor connection terminal and cable
•
This inverter is not designed for use with a power supply of
18000 (12000) Arms or above [maximum voltage: 240 (120) VAC].
•
Always use this inverter in combination with a compatible motor by
Oriental Motor (refer to p.15).
The compatible motors listed in this manual are recognized by UL and
certified by CSA and provide an overheat protection function based on
impedance protection or thermal protection.
Hazardous substances
RoHS (Directive 2002/95/EC 27Jan.2003) compliant
– 4 –
Location Tightening torque
0.86 to 0.96 N·m
Wire range
AWG14