Starting A Wash Cycle; Changing A Programme - Kenwood KDW12SL3A User Manual

starting a wash cycle

Please follow the steps below to start a wash cycle.
1. Ensure the unit is connected to the mains power and the water
supply is on (water pressure between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes
and push the baskets back. It is recommended that the lower basket
is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent
compartment and close firmly afterwards.
4. Press the ON/OFF button.
5. Select the wash cycle programme based on the loading and soil
requirements. Please refer to the "Wash Cycle Table" (page 13).
6. The indicator light of the selected programme will illuminate.
7. Close the dishwasher door. A click sound should be heard when
the door is closed correctly. Do not slam the door.
8. The washing cycle will begin shortly.
NOTE: If you open the dishwasher door during the washing cycle and
then close it, the dishwasher will continue the current washing
programme after 10 seconds. However, if the door is not closed
correctly after 1 minute, the dishwasher will make an audible sound at 1
minute intervals.

changing a programme

To change the programme if the washing cycle has already started,
follow the steps below.
1. Before open the door, please press the start/pause button, then the
unit stop working, next open the door slightly to check if the unit
has dispensed the detergent or detergent tablet. This will depend on
how long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you allow the
wash cycle to finish, then close the dishwasher door, you need press
the start/pause button, the unit will start the new washing cycle
shortly.
3. If the detergent dispenser lid is still closed, then close the dishwash
door, press and hold down the programme button for 3 seconds
to cancel the programme. You can then press the required new
programme button. Next you need press the start/pause button, the
unit will start the new washing cycle shortly.
GB-24
Kenwood KDW12SL3A_IB_100924_Zell.indd 24 24/09/2010 10:39 AM