Starting A Wash Cycle; Changing A Programme; At The End Of A Programme - Kenwood KDWTTB10 Installation Instructions Manual

starting a wash cycle

Please follow the steps below to start a wash cycle.
1. Ensure the unit is connected to the mains power and the water supply is on (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher baskets, load the dishes and push the baskets back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do
not slam the door.
5. Press the on/off button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to
the "Wash Cycle Table" (page 12).
7. The indicator light of the selected programme will illuminate.
8. Press start/reset button, the washing cycle will begin shortly.
If you open the dishwasher door during the washing cycle and then close it, the dishwasher
will continue the current washing programme after 10 seconds. However, if the door is not
closed correctly after 1 minute, the dishwasher will beep at 1 minute intervals.

changing a programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Press start/reset button to pause the unit, open the door slightly to check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for.
2. If the detergent dispenser lid is opened, we suggest that you allow the wash cycle to finish.
3. If the detergent dispenser lid is still closed, press and hold down the programme button for 3
seconds to cancel the programme. You can then press the required new programme button and
close the dishwasher door. The unit will start the new washing cycle shortly.
4. The display window shows the state of the dishwasher.
a. "-:--" means the unit is on stand by mode.
b. "H:MM" and not flashing means the unit is on pause.
c. "H:MM" and flashing means the unit is running.

at the end of a programme

At the end of a programme, the dishwasher will beep.
20