Maxi Dot (Information Display) - Skoda Rapid Owner's Manual

Average speed
The average speed since the memory was last erased is shown in the display in
km/hour » page 12. To determine the average speed over a certain period of time,
set the memory to zero at the start of the measurement using button
» Fig. 5 » page 12.
B
After erasing the memory, no value appears in the display until you have driven
approx. 300 m.
The display is updated regularly while you are driving.
Current speed
The current speed which is identical to the display of the speedometer
» Fig. 2 » page 8 is indicated on the display.
3
Oil temperature
If the oil temperature is lower than 50 °C or if a fault in the system for checking
the oil temperature is present, only - -.- is displayed instead of the oil tempera-
ture.
Warning against excessive speeds
ä
First read and observe the introductory information and safety warn-
ings on page 11.
Adjust the speed limit while the vehicle is stationary
›
With button » Fig. 5 » page 12, choose the menu Warning against excessive
A
speeds.
›
Press the button to activate the ability to set the speed limit.
B
›
Use the button to set the required speed limit, e.g. 50 km/h.
A
›
Confirm the speed limit by pressing button
settings are saved automatically.
This allows you to set the speed in 5 km/h intervals.
Adjusting the speed limit while the vehicle is moving
›
With button » Fig. 5 » page 12, choose the menu Warning against excessive
A
speeds.
›
Drive at the desired speed, e.g. 50 km/h.
›
Press button to accept the current speed as the speed limit.
B
If you wish to change the set speed limit, it is changed in 5 km/h intervals (e.g. the
accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).
›
Confirm the speed limit by pressing button
Your settings are saved automatically.
14
Using the system
, or wait several seconds. Your
B
again, or wait several seconds.
B
Change or delete speed limit
›
With button » Fig. 5 » page
A
speeds.
›
Pressing the button deletes the speed limit.
B
›
Pressing the button activates the ability to change the speed limit.
B
If the set speed limit is exceeded, an acoustic signal will sound as a warning. At
the same time the message Warning against excessive speeds appears on the
display with the set limit value.
The set speed limit value remains stored even after switching off the ignition.

MAXI DOT (information display)

ä
Introduction
Ð
This chapter contains information on the following subjects:
Main menu
Settings
Door, luggage compartment door and bonnet ajar warning
Auto Check Control
The information display provides you with information on the current operating
state of your vehicle. The information system also provides you with data relating
to the radio, mobile phone, multi-functional indicator, navigation system, the unit
connected to the MDI input and the automatic gearbox
WARNING
Concentrate fully at all times on your driving! As the driver you are fully re-
sponsible for road safety.
12, choose the menu Warning against excessive
» page 78.
Ð
15
15
16
16
Ð