Maxi Dot (Information Display); Current Speed; Oil Temperature; Warning Against Excessive Speeds - Skoda 2012 Superb Owner's Manual

A zero appears in the display for the first approx. 300 m you drive after erasing
the memory.
The indicated value will be regularly updated while you are driving.

Current speed

ä
First read and observe the introductory information and safety warn-
ings on page 14.
The current speed which is identical to the display of the speedometer
is indicated on the display.

Oil temperature

ä
First read and observe the introductory information and safety warn-
ings on page 14.
If the oil temperature is lower than 50 °C or if a fault in the system for checking
the oil temperature is present, three lines are displayed instead of the oil temper-
ature.

Warning against excessive speeds

ä
First read and observe the introductory information and safety warn-
ings on page 14.
Adjust the speed limit while the vehicle is stationary
›
With the button on the windshield wiper lever
A
wheel on the multi-function steering wheel
D
Warning against excessive speeds.
›
Activate the option for setting the speed limit (the value flashes) with the but-
ton on the windshield wiper lever, or the adjustment wheel
B
function steering wheel.
›
Set the desired speed limit, e.g. 50 km/h, with the button
wiper lever or the adjustment wheel
›
Use the button on the windshield wiper lever or the adjustment wheel
B
on the multi-function steering wheel to confirm the desired speed limit, or wait
around 5 seconds and the setting is saved automatically (the value stops flash-
ing).
18
Using the system
2
» Fig. 7 or the adjustment
» Fig. 7, select the menu point
on the multi-
D
on the windshield
A
D on the multi-function steering wheel.
This allows you to set the speed in 5 km/h intervals.
Adjust the speed limit while the vehicle is moving
›
 Select the menu point Warning against excessive speeds with the button
on the windshield wiper lever or the adjustment wheel
steering wheel.
›
Drive at the desired speed, e.g. 50 km/h.
›
Use the button on the windshield wiper lever or the adjustment wheel
B
on the multi-function steering wheel to accept the current speed as the speed
limit (the value flashes).
If you wish to change the set speed limit, it is changed in 5 km/h intervals (e.g. the
» Fig. 2
accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).

›
Repeatedly press the button
ment wheel on the multi-function steering wheel to confirm the desired
D
speed limit, or wait around 5 seconds and the setting is saved automatically
(the value stops flashing).
Change or delete speed limit
›
Select the menu point Warning against excessive speeds with the button
on the windshield wiper lever or the adjustment wheel
steering wheel.
›
Pressing the button

D on the multifunction steering wheel deletes the speed limit.
›
Pressing the button
on the multifunction steering wheel again activates change mode for the
D
speed limit.
If the set speed limit is exceeded, an acoustic signal will sound as a warning. At
the same time the message Warning against excessive speeds appears on the
display with the set limit value.
The set speed limit value remains stored even after switching off the ignition.

MAXI DOT (information display)

ä
Introduction
This chapter contains information on the following subjects:
D
Main menu
Settings
Door, luggage compartment door and bonnet ajar warning
D
on the windshield wiper lever or the adjust-
B
D
on the windshield wiper lever or the adjustment wheel
B
on the windshield wiper lever or the adjustment wheel
B
A
on the multi-function
D
A
on the multi-function

19
20
21
£