Opening And Closing The Door - Miele G 7859 Operating Instructions Manual

Electric door lock
The machine is equipped with an
electric door lock.
The door can only be opened when:
^ the machine is connected electrically
^ the main switch I-0 is on.
To open the door a
^ Press the door button in fully and at
the same time pull open the door.
,
Do not touch the heating
elements if you open the door during
or directly after the end of a
program. The heating elements
remain hot for some time after the
end of a program.
To close the door
^ Lift the door upwards until it clicks
into position. Do not push in the door
release button as you do so.
The door is locked approx. 1.5 mins.
after program start, except in the
program D (PRE-RINSE),
6 (DRAIN) and during the drying
phase (additional program).
The door remains locked until the end
of the program, when it can be opened
again.

Opening and closing the door

Cancelling a program
If a program has to be cancelled in
extreme cases, e.g. when articles in the
machine jostle against each other or the
program is interrupted with a fault
indication, the door must be opened
(deliberate intervention):
^ Turn the program selector switch to f
(the program is cancelled after approx.
2 secs.).
Important: Further procedures are
described in the section "Switching on
and off" under "Cancelling a program".
Opening the door with the
emergency release
The emergency release should only
be used when the door cannot be
opened normally (e.g. power failure).
^ Turn the program selector switch to f.
^ Switch off the machine (I-0 switch).
^ Pull down the emergency release
behind the door outer panel.
11