Miele G 7859 Operating Instructions Manual page 33

4. Venting and setting the dosage on
"DOS module G 60 or C 60" (special
version)
^ Set the dosage selector on the DOS
module to the "10" position (on DOS
module C 60 only).
^ Turn the program selector to the f
"STOP" position.
^ Switch off the machine.
^ Press 4 and 6 at the same time,
hold them in and while doing so
switch the machine on with the I-0
button.
The current program status "P..."
appears in the display.
The p / 6 indicator light comes on.
^ Press 3 twice, "E02" (programming
level 2) appears in the display.
Venting the dispensing system:
^ Turn the program selector to the p
position. "do1" appears in the
display.
^ Press 4 for 90 seconds.
The dispensing system is vented.
If only venting is required:
^ Switch the machine off with the I-0
button.
^ Immediately after this: start the D
(COLD) program, so that after
venting any agents in the wash
cabinet are diluted before being
drained away.
Programming special functions
Setting the dosage:
Set the amount to dispense
according to the detergent
manufacturer's recommendations.
The machine needs 7 litres of water in
the "Main wash" program stage.
Example:
The detergent manufacturer
recommends 4 ml cleaning agent per
litre of water.
7 l x 4 ml/l = 28 ml.
2 ml . 1 sec. dispensing time; i.e.
programming to 14 secs.
^ Turn the program selector to the q
position, the dispensing time in
seconds appears in the display, e.g
"10".
^ Press 4 repeatedly or hold it in, until
the number "14" appears in the
display (dispensing time 14 seconds
. 28 ml - see example).
The dispensing time/amount is set.
Having changed a value or all values:
^ Press 6. "SP" appears in the display.
^ Press 6 again. The change has
been recorded.
Value set:
If the dispensing system also needs to
be vented:
^ Start the D (DRAIN) program, so that
after venting any agents in the wash
cabinet are diluted before being
drained away.
33