To Pair Output Mixes As Stereo; Setting The Mix Levels - Yamaha PM5D Quick Start Manual

Studio manager and pm5dv2 editor

Hide thumbs Also See for PM5D:

Table of Contents

To pair output mixes as stereo;

Output naming;

In the Editor, output mix names can be entered on either

the patch window or the main MIX, MATRIX or STEREO

channel windows. Rapid naming is easiest in the channel

windows as the Tab key can be used to move to the next

name. Double click on the name to highlight it, then type

in the name. Output names are useful in the Editor and ap-

pear on the console in the relevant screens. Output names

only appear on the panel surface when the Assignable

Faders are used.

PM5D / PM5D-RH Quick Start Guide Part 3

On the console worksurface we can press and hold two

[SEL] buttons to make a pair, but in the Editor we must

use the Selected Channel window. Click on the

heart icon to make a paired (stereo) channel. All param-

eters except pan are linked. Remember the pan needs to

be set; you can do this in the Selected Channel window or

in the MIX window.

If you want to set a rough mix for FOH you can easily

drag the input faders to their levels, but for monitors there

is no Fader Flip or Sends on Fader type mode. The easiest

way is to use the SEL channel window and drag the rotary

knobs to set the levels. At this early stage the process is

almost meaningless, and could cause more problems than

leaving the values at zero, but later, after the soundcheck

and ﬁ rst show this is how to make adjustments.

This is also the most accurate way to make mix send ad-

justments via a tablet type controller.

Table of Contents

Pm5d-rh