Basic Connections - JVC HR-XVS20EK Instructions Manual

Basic Connections

Aerial connector
Back of TV
21-pin SCART
connector
21-pin SCART
cable
(not provided)
Mains power cord
Back of unit
Mains outlet
Make AV connection if your TV has a 21-pin AV input
connector (SCART) in order to reduce the possibility of
interference. With AV connection, you can enjoy stereo
playback of video tapes if you are using a stereo TV.
In addition, if you connect the unit to the TV's RGB
connectors, set the output mode for the L-1 IN/OUT
connector so that the RGB signal is output from the unit.
When the DVD deck is selected, press and hold 8 until
the desired mode appears on the front display panel.
yc : Select when your TV is compatible with the Y/C
signal. Y/C signal is output from the unit. Also
set "L-1 OUTPUT" to "S-VIDEO". (
rgb : Select when your TV is compatible with the
RGB signal. RGB signal is output from the unit.
NOTES:
Set your TV to the VIDEO (or AV), Y/C, or RGB mode
according to the type of your TV's SCART connector.
For switching the TV's mode, refer to the instruction
manual of your television.
TV aerial
cable
RF cable
(provided)
ANTENNA
IN
L-1 IN/OUT
ANTENNA
OUT
pg. 62)
It's essential that your unit be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
A
Situate the unit.
Place the unit on a stable, horizontal surface.
B
Connect the unit to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8 To connect to a TV with NO AV input connectors —
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN
connector on the rear panel of the unit.
C Connect the provided RF cable between the
ANTENNA OUT connector on the rear panel of the
unit and the TV's aerial connector.
AV Connection
8 To connect to a TV with AV input connectors —
A Connect the aerial, unit and TV as per "RF
Connection".
B Connect an optional 21-pin SCART cable between the
L-1 IN/OUT connector on the rear panel of the unit
and the TV's 21-pin SCART connector.
C Set the output mode for the L-1 IN/OUT connector
depending on type of your TV. (
C
Connect the unit to mains.
Plug the end of the mains power cord into a mains outlet.
After the connection is completed, perform "Auto Set
Up" on page 16.
15
left column)